14-11-2017 12:16:39

ISH 35M

Walther/ISH 35M kal. 22lr.

Matchpistol af bedste russiske kvalitet.
Konstrueret til det russiske landshold som et prestigeprojekt.
Et rigtigt godt bud på en konkurrencepistol til en fornuftig penge.
Importeret af Walther, der selvfølgelig har stået for kvalitets kontrol.
Pistolen er monteret med et godt matchgreb af Walthers egne.
En særdeles slidstærk og pålidelig pistol også til foreningsbrug.
Gode sigtemidler med justerbart microvisir.
Justerbart aftræk, fortræk, aftræksstop og vægt, desuden kan aftrækkeren flyttes inden for 25 mm. så den kan tilpasses til lange eller korte fingre.
God balance og et godt greb med justerbar håndbaldestøtte.
Pistolen har omvendt hanefald, der reducerer rekylen uden brug af kontravægte eller kompensator.

Magasinet indeholder 6 skud.
Pibelængde 150 mm. Totallængde 270 mm. Vægt 1204 gram.

Dette våben kan desværre ikke leveres som nyt mere.

Trigger adjustment
N.B.:

For trigger adjustment, the grip must be removed (see under Stripping the pistol). For the following settings, the lever (j) must be operated if it has been activated.
Basic adjustment
(Figs. 1 and 2)
- Turn screw (c) counterclockwise (about 2 turns). - Cock the trigger by drawing back the slide assembly - if the trigger cannot be cocked, turn the screw (e) clockwise until the hammer is free, then turn the screw (e) about a 1/2 to a 3/4 turn counterclockwise in order to achieve the minimum permissible engagement of the pawls (g) and (h).
Setting the trigger slack
(Fig. 2)
- Turn the screw (b) clockwise until the trigger bar (f) is resting on the pawl (h), then swing the trigger bar slightly downwards with the finger and turn the screw (b) one turn.
- Release the trigger bar and turn the screw (b) counter- clockwise until the trigger bar (f) engages in the pawl (h). From here the required trigger slack can be selected by further counterclockwise turning of the screw (b).
If the enhanced safety is to be activated, turn the screw about a half-turn more counter- clockwise.
Setting the trigger stop
(Fig. 2)
- Cock the hammer, then turn the screw (c) clockwise until the hammer can no longer be released.
- Pull the trigger, turn the screw (c) counterclockwise until the hammer strikes, then turn the screw (c) a further quarter-turn counterclockwise.
Setting the trigger pull
(Fig. 2) The trigger pull is set using the screw (a).
Setting the trigger finger
position (Fig. 2) Undoing the screw (d) permits appropriate adjustment of the finger position.


Denne side bibeholdes på vores side som oplysning og vil senere blive flyttet til en bedre egnet placering.

Indkøbsliste